Products

PSM 300 Wireless In-Ear Monitoring Kit with One Bodypack Receiver

psm300-kit.jpg
psm300-kit.jpg

PSM 300 Wireless In-Ear Monitoring Kit with One Bodypack Receiver

799.00

The PSM 300 Stereo Personal Monitor System delivers detailed 24-bit digital audio and reliable wireless freedom to every corner of the stage. Patented Audio Reference ensures the clearest sound, with ultra-low noise and no artifacts. Dependable wireless coverage extends over 300 ft (90 m) of range and eliminates dropouts. Easy to setup and operate, PSM 300 systems offer one-touch frequency scan and sync to find and assign a clean wireless channel. Adjust the volume using MixMode® technology or stereo mode to create a personal mix from two channels of audio.

Frequency:
Quantity:
Add To Cart

P3T Wireless Transmitter for PSM300

Performance

RF Output Power    10, 20, 30 mW
Note: varies by region
RF Output Impedance    50 Ohms (typical)
Transmission Range    300' (90 m)

Audio Input

Connector Type    1/4" TRS (6.35 mm)
Polarity    Tip positive with respect to ring
Configuration    Electronically balanced
Impedance    40 kOhms (actual)
Nominal Input Level    Switchable, +4 dBu, -10 dBV
Maximum Input Level    +4 dBu: +22 dBu
-10 dBV: +12.2 dBu
Pin Assignments    Tip=hot, Ring=cold, Sleeve=ground
Phantom Power Protection    Up to 60 VDC

Audio Output

Connector Types    1/4" TRS (6.35 mm)
Configuration    Electronically balanced
Impedance    Connected directly to inputs

General

Antenna    1/4 wave, detachable
Power Requirement    12 to 15 VDC, 260 mA maximum
Dimensions (H x W x D)    1.7 x 7.8 x 6.8" (43 x 198 x 172 mm)
Net Weight    27.6 oz (783 g)

P3R-H20 Wireless Bodypack Receiver for PSM300

RF Sensitivity    Active: 2.2 μV (at 20 dB SINAD)
Image Rejection    >90 dB
Adjacent Channel Rejection    >60 dB
Intermodulation Attenuation    >50 dB
Blocking    >60 dB
Audio Output Power    1 kHz @ <1% distortion, Peak Power, @32 ohms: 80 mW (per output)
Minimum Load Impedance    16 ohms
Headphone Output    1/8" (3.5 mm) stereo
Battery Life    5-7 hours (continuous use) AA batteries
Dimensions (H x W x D)    4.3 x 2.5 x 0.8" (110 × 64 × 21 mm)
Weight    3.5 oz (98 g) without batteries

Packaging Info

Box Dimensions (LxWxH)    11.1 x 5.3 x 3.3"
SE112 Sound Isolating Earphones (Gray)
Type    Single dynamic MicroDriver
Sensitivity    108 dB SPL/mW
Frequency Range    25 Hz to 17 kHz
Cable Length    50" (127 cm)